Skip to content
Research Article Open access CC BY 4.0

Gilbert-Cell Mixer for WiMAX Applications

Frederick Ray I. Gomez

Journal of Engineering Research and Reports · pp. 1–9 · Published 9 Oct 2018

10.9734/jerr/2018/v2i310956

Abstract

Differential implementation is becoming highly popular in Radio Frequency Integrated Circuit (RFIC) design, notably for its high immunity to common-mode noises, acceptable rejection of parasitic coupling, and increased dynamic range. One RF front-end building block that is usually designed as a differential circuit is the mixer. This paper presents a design, study, and optimization of a differential mixer, more specifically the Gilbert-cell mixer (also known as double-balanced mixer) implemented on a direct-conversion architecture in a standard 90 nm Complementary Metal-Oxide Semiconductor (CMOS) process. Operating frequency is set to 5GHz, which is a typical frequency for Worldwide Interoperability for Microwave Access (WiMAX) receiver. Impedance matching was necessary to design and fully optimize the mixer design. The direct-conversion Gilbert-cell mixer design ultimately achieved conversion gain of 11.463dB and noise figure of 16.529dB, comparable to mixer designs from past research and studies.

Gilbert-cell mixer direct-conversion conversion gain noise figure WiMAX

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

0

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.