Design of Common-gate with Common-source Active Balun for WiMAX Receiver Front-end
Frederick Ray I. Gomez, Maria Theresa G. De Leon, John Richard E. Hizon
Journal of Engineering Research and Reports · pp. 1–9 · Published 2 Jul 2019
10.9734/jerr/2019/v6i116939Abstract
This paper presents a design and simulation study of a common-gate with common-source active balun circuit implemented in a standard 90-nm complementary metal-oxide semiconductor (CMOS) process. The active balun design is intended for worldwide interoperability for microwave access (WiMAX) application, with operating frequency of 5.8 GHz and supply voltage of 1 V. Measurements are taken for parameters namely gain difference, phase difference, and noise figure. The common-source active balun design achieved a minimal gain difference of 0.04 dB, phase difference of 180 ± 1.5 degrees, and noise figure of 8.76 dB, which are comparable to past active balun designs and researches. The design eventually achieved a low power consumption of 4.45 mW.
Cited by 0
No indexed citations yet.
Related research
- Gilbert-Cell Mixer for WiMAX Applications — shares topic coverage
- Differential Active Balun Design for WiMAX Applications — shares topic coverage
- Design of Common-Source/Drain Active Balun Using 90nm CMOS Technology — shares topic coverage
Article metrics
Real usage data collected on this platform.
0
Page views
0
PDF downloads
0
Outbound clicks
0
Citations
Views by country
Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".
No views recorded yet.
Traffic sources
Referring site, by host.
No traffic recorded yet.
Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.