Skip to content
Research Article Open access CC BY 3.0

Optimisation of Plantain - Brewers’ Spent Grain Biscuit Using Response Surface Methodology

O. S. Omoba, O. O. Awolu, A. I. Olagunju, A. O. Akomolafe

Journal of Scientific Research and Reports · pp. 665–681 · Published 27 Aug 2013

10.9734/JSRR/2013/4944

Abstract

Aim: To optimize the formulation of plantain – brewers’ spent grain biscuits using Response Surface Methodology with the purpose of achieving the maximum quality and overall acceptability of produced biscuits. Study Design: Central composite design model of Response surface methodology was employed to design the work. This produced thirteen experimental runs, the variables considered were Brewer’s spent grain (94-97 %) and plantain flour (3-6 %) while the responses were percentage soluble dietary fibre, percentage insoluble dietary fibre and iron contents. Place and Duration of Study: Department of Food science and Technology, Federal University of Technology, Akure, Nigeria, between January to December 2012. Methodology: The variables considered for the research were Brewer’s spent grain (94-97 %) and plantain flour (3-6 %) while the responses were percentage soluble dietary fibre, percentage insoluble dietary fibre and iron contents. Thirteen (13) runs were obtained.The optimization was carried out on plantain flour and brewer’s spent grain in order to know which of the combinations will give best total dietary fibre and iron content. Results: Optimized values, which are the highest total dietary fibre and iron values of 68.55 % and 0.80 mg /100g respectively, were obtained from blends of 95.5 % and 4. 5 % of plantain flours and Brewer’s spent grains respectively (PS 4). The best response surface model for the insoluble dietary fibre was quadratic that of soluble dietary fibre was linear while it was quadratic also for iron content. The lack of fit, (p=0.4208) is non significant. A non significant lack of fit is required confirming that, the model of is adequate. The R2 value of 52 % signifies a good model. This is in view of the fact that R2 must be at least 50 % to be a good model. Conclusion: Response Surface Methodology was effective in optimizing iron and dietary fibre in the formulation of plantain-spent grain biscuit. The nutritional composition of the plantain-spent grain biscuit indicated good levels of dietary fibre (IDF, SDF and TDF), Iron.

Response surface methodology plantain flour brewers spent grain total dietary fiber iron content

Cited by 29

Antioxidant, functional and rheological properties of optimized composite flour, consisting wheat and amaranth seed, brewers’ spent grain and apple pomace

O. Awolu, Richard Onyemaechi Osemeke, B. O. Temilade Ifesan · Journal of food science and technology · 2016

Evaluation of particle size, flowability and thermal properties of formulated composite wheat-sologold sweet potato flour for baked products

Tosin Paul, William Adebisi Olosunde, Orua Okon Antia · International Journal of Physical Sciences · 2024

Physical properties and consumer acceptance of maize-baobab snacks

Miranda Netshishivhe, Adewale Olusegun Omolola, Daniso Beswa · Heliyon · 2019

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

29

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.