Wirebond Process Optimization through Stitch Relocation on QFN Package
A. Moreno, E. Graycochea Jr., F. R. Gomez
Journal of Engineering Research and Reports · pp. 26–30 · Published 2 Dec 2020
10.9734/jerr/2020/v19i217228Abstract
One of the most challenging assembly manufacturing process in semiconductor industry is wirebond process using a wire as direct material. With this new technology, some issues were encountered during the first trial of a quad flat no-leads (QFN) package. This paper is focused on the heal crack seen on the stitch formation during second bond. A comprehensive improvement was done by relocating the stitch formation on the second bond. Ultimately, heal crack occurrence was successfully eliminated.
Cited by 0
No indexed citations yet.
Related research
- Wirebond Solution of Semiconductor IC Package through Modeling and Simulation — shares topic coverage
- Modified Sidewall Design of QFN Package — shares topic coverage
- Warpage Mitigation through Diebond Process Improvement with Enhanced Leadframe Configuration — shares topic coverage
- ESD Diode Protection Incorporated on Leadframe Package — shares topic coverage
- Die Attach Process Optimization with Enhanced Epoxy Control on Leadframe Package — shares topic coverage
Article metrics
Real usage data collected on this platform.
0
Page views
0
PDF downloads
0
Outbound clicks
0
Citations
Views by country
Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".
No views recorded yet.
Traffic sources
Referring site, by host.
No traffic recorded yet.
Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.