Skip to content
Research Article Open access CC BY 4.0

Capacity Improvement for Transfer Molding Trough Reduction of Mold Curing Time

Lester Joseph T. Belalo, Maiden Grace R. Maming

Journal of Engineering Research and Reports · pp. 125–141 · Published 19 Feb 2021

10.9734/jerr/2021/v20i217272

Abstract

This paper will discuss the improvement made to increase machine capacity in order to be prepare for incoming demand ramp-up and to free up machine allocation to back-up automotive machine. Using DMAIC methodology (Define, Measure, Analyze, Improve and Control) approach, mold curing time identified as the top contributor during time study of the process with 120 secs consumed time per shot. A Differential Scanning Calorimetry (DSC) and Curability Curve study for molding compound was conducted from both internal and external expertise to get the optimum lower range of cure time. Considering all the quality risk using Risk assessment, the success of reducing Mold curing time from 120secs to 80secs increases 25% machine capacity of transfer Molding for Quad Flat No leads(QFN) / Quad Flat No leads multi-Row(QFN-mR) with significant cost savings. The project was able also to free up 3 molding system to support upcoming products.

Capacity transfer mold mold curing time cure time reduction.

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

0

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.