Skip to content
Research Article Open access CC BY 3.0

Performance Evaluation of Photo and Biodegradation of Low Density Polyethylene Using Photodegradable Additive Ferrocene [Part – II]

Rajshree Vijayvargiya, A. K. S. Bhadoria, Ajay Kumar Nema

Current Journal of Applied Science and Technology · pp. 1657–1683 · Published 18 Feb 2014

10.9734/BJAST/2014/4813

Abstract

The Ferrocene additive is also reported as UV active and giving absorption peak of 220-260 nm at 2.8 X 10-3 mol/l. Ferrocene additive was melt blended with LDPE at 3 different concentration of ferrocene i.e. 1, 2 & 3% using twin screw extruder. After blending with LDPE the performance of photo and bio degradation was evaluated. The films were evaluated for their mechanical, thermal, infrared spectroscopic analysis, and morphological characteristics. The results show that ferrocene can be used as an effective photo-biodegradable additive. The photo degradation rate of the additive is very high at high concentration of ferrocene additive and the biodegradation was also proving that some low molecular weight species was formed during photo degradation, which is responsible for the 22% biodegradation after 47 days.

Photo degradation Ferrocene Biodegradation Low density Polyethylene (LDPE).

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

0

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.