Skip to content
Research Article Open access CC BY 4.0

A Study of Dispense Needle for Die Attach Voids Mitigation

R. Rodriguez, B. C. Bacquian, F. R. Gomez, E. Graycochea Jr.

Journal of Engineering Research and Reports · pp. 25–29 · Published 29 Jun 2020

10.9734/jerr/2020/v14i117114

Abstract

The need of data storage devices and new technologies continues to grow with more robust and stable functioning capability. With that, improvement and utilization never stop for a seamless output. One device that is currently on new product introduction is a quad-flat no-leads (QFN) utilizing a tapeless leadframe technology. The new device used highly conductive glue with metal spacer and has experienced gross glue voids defect parts per million (ppm). Glue voids were measured for cumulative voids criteria, with values higher compared to the specification. The study used analysis of variance (ANOVA) on the dispense needle diameter and revealed the effect levels of needle diameter on cumulative voids reduction. For subsequent works, the configuration could be applied for packages with similar requirement.

Die attach process QFN dispense needle glue voids.

Cited by 1

Process Optimization Study on Leadframe Surface Enhancements for Delamination Mitigation

Salvador C. Buenviaje, Rennier S. Rodriguez, Rammil A. Seguido · 2020 IEEE 22nd Electronics Packaging Technology Conference (EPTC) · 2020

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

1

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.