Skip to content
Research Article Open access CC BY 3.0

Bioremediation of Chromium, Nickel and Zinc in Electroplating Effluent by Escherichia coli

G. Suresh Kumar, A. J. Thatheyus

Annual Research & Review in Biology · pp. 913–920 · Published 9 Aug 2013

Abstract

Effluent samples from an electroplating industry located at Madurai, India were collected and analysed for chosen physico-chemical parameters. Among the heavy metals tested, zinc exhibited highest level with 739 ppm with a pH of 4.83. The bacterial strain isolated from the effluent contaminated site was identified as Escherichia coli and it was subjected to 15, 20 and 25% of effluent in minimal broth for 20 days. Optical density and pH changes were recorded daily and the levels of chromium, nickel and zinc were analysed after ten and twenty days of treatment. Significant reduction in the level of zinc was observed and the results are discussed.

Electroplating effluent Escherichia coli bioremediation chromium nickel and zinc

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

0

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.