Skip to content
Research Article Open access CC BY 3.0

Conversion of Low Density Polyethylene (LDPE) and Polypropylene (PP) Waste Plastics into Liquid Fuel Using Thermal Cracking Process

Moinuddin Sarker, Mohammad Mamunor Rashid, Md. Sadikur Rahman, Mohammed Molla

International Journal of Environment and Climate Change · pp. 1–11 · Published 29 Feb 2012

10.9734/BJECC/2012/994

Abstract

In every sector of the world today energy is essential. Energy has many forms such as electricity, transportation fuel and so on. A large amount of energy is produced from crude oil, which is used to produce petroleum and petroleum to produce daily usable plastics. The solution to the above mentioned problems can be solved through the utilization of the new develop technology. This new developed technology will remove these hazardous waste plastics from the environment and convert them into eco friendly liquid fuel. The process is used to convert these waste plastics into liquid fuel creates no harmful emissions and can be produced at a very little overall cost. The thermal process utilized to break down the hydrocarbon chains of the polymers and convert them into liquid fuel. A Steel reactor with temperature range from 100 ºC to 400 ºC is utilized for the plastic thermal degradation process. The process yield about 80-90% liquid product. The experiment is conducted under a fume hood and open air system, no vacuum process is applied in this particular thermal cracking process.

Renewable energy thermal cracking fuel environment waste plastic hydrocarbon gas

Cited by 35

Catalytic reforming of gaseous products from pyrolysis of low-density polyethylene over iron-modified ZSM-5 catalysts

A. Y. Waziri, Aisha A. Osigbesan, F. Dabai · Applied Petrochemical Research · 2019

3Rs Policy and plastic waste management in Thailand

N. Wichai-utcha, Orathai Chavalparit · Journal of Material Cycles and Waste Management · 2018

Catalytic co-cracking of waste polypropylene and residual fuel oil

P. Kasar, M. Ahmaruzzaman · Petroleum science and technology · 2018

On the applicability of composite PA6-TiO2 filaments for the rapid prototyping of innovative materials and structures

Rupinder Singh, Ranvijay Kumar, Ida Mascolo · Composites Part B: Engineering · 2018

Synthesis of Hydrocarbon Fuel by Thermal Catalytic Cracking of Polypropylene

J. Habyarimana, Mohammed Njiemon, Raiyan Abdulnasir · 2017

Pyrolytic Waste Plastic Oil and Its Diesel Blend: Fuel Characterization

M. Z. Khan, M. Sultana, M. Al-Mamun · Journal of Environmental and Public Health · 2016

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

35

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.