Skip to content
Research Article Open access CC BY 3.0

Potentiometric Determination of Nickel (II) Ion Using Zirconium (IV) Antimono Tungstate as an Electroactive Material

Harish K. Sharma, Pernita Dogra, Nitika .

Chemical Science International Journal · pp. 457–471 · Published 15 Feb 2014

10.9734/ACSJ/2014/5527

Abstract

Aims: The research work is based on the fabrication of ion selective Electrode based on Zirconium (IV) antimono tungstate. Study Design: The Study was designed to make ion selective electrode for transition metal ions. Place and Duration of Study: Department of Chemistry, M M. University, Mullana (Ambala). It can be used for five months i.e Jan - May 2013, with a good reproducibility. Methodology: Zirconium (IV) antimono tungstate having ion exchange capacity of 0.30 meq g-1 for Na+ ion was synthesized by sol –gel method and characterized by physicochemical techniques. The proposed electrode was prepared by mixing the ionophore with the required amount of epoxy resin. Then potentiometric studies were carried out. Results: Epoxy-based membrane of zirconium (IV) antimono tungstate (50% ZrSbW and 50% epoxy resin) reveals a sub-Nernstian potentiometric response with the slope of 20 mV per decade for Ni2+ over a wide concentration range (10−6 to 10−1 M). The response time of the electrode is quite low and could be used for a period of 5 months with a good reproducibility. The proposed electrode reveals very high selectivity for Ni2+ in the presence of a wide variety of metal ions such as Zn2+,  Pb2+, Cd2+, Cu2+, Ce3+, Na+, Ca2+, Mg2+, Pr3+ Y3+ and Fe3+ at concentrations 1×10−3 M and 1×10−4 M. Effect of internal solution concentration was studied. The proposed sensor can be used in the pH range of 2.90 - 9.20. It was used as an indicator electrode in the potentiometric titration of Ni2+ ions against EDTA. Conclusion: Zirconium (IV) antimono tungstate can be successfully used as electro-active material for making a nickel (II)-selective membrane electrode. The proposed electrodes have reasonably good lifetime, detection limit, pH range and selectivity coefficient. They can also be used as indicator electrodes for trace level determination of Nickel ions.

ISE Ni (II) FIM Potentiometric titration

References (34)

  1. 1 A Quantitative Analysis
  2. 2 Selectivity coefficients for ion-selective electrodes: Recommended methods for reporting KA,Bpot values (Technical Report) [DOI]
  3. 3 Elements and Their Compounds in the Environment [DOI]
  4. 4 New nickel(II) selective potentiometric sensor based on 5,7,12,14-tetramethyldibenzotetraazaannulene in a poly(vinyl chloride) matrix [DOI]
  5. 5 Schiff's Bases and Crown Ethers as Supramolecular Sensing Materials in the Construction of Potentiometric Membrane Sensors [DOI]
  6. 6 Porphyrins as carrier in PVC based membrane potentiometric sensors for nickel(II) [DOI]
  7. 7 Determination of Pb2+ ions by a modified carbon paste electrode based on multi-walled carbon nanotubes (MWCNTs) and nanosilica [DOI]
  8. 8 Developments in the Field of Conducting and Non-conducting Polymer Based Potentiometric Membrane Sensors for Ions Over the Past Decade [DOI]
  9. 9 Automated on-line separation–preconcentration system for inductively coupled plasma atomic emission spectrometry and its application to mercury determination [DOI]
  10. 10 Ni(II)-selective ion sensors of salen type Schiff base chelates [DOI]
  11. 11 A Novel Sensor for Monitoring of Iron(III) Ions Based on Porphyrins [DOI]
  12. 12 Potentiometric Zinc Ion Sensor Based on Honeycomb-Like NiO Nanostructures [DOI]
  13. 13 Highly selective and sensitive copper(II) membrane coated graphite electrode based on a recently synthesized Schiff’s base [DOI]
  14. 14 The effect of polymeric supports and methods of immobilization on the performance of an optical copper(II)-sensitive membrane based on the colourimetric reagent Zincon [DOI]
  15. 15 The fabrication of potentiometric membrane sensors and their applications [DOI]
  16. 16 A zinc-selective electrode based on N,N′-bis(acetylacetone)ethylenediimine [DOI]
  17. 17 Nafion-based optode for the detection of metal ions in flow analysis [DOI]
  18. 18 Nickel(II)-selective membrane potentiometric sensor using a recently synthesized Schiff base as neutral carrier [DOI]
  19. 19 Direct Determimnation of Mercury in Sediments by Atomic Absorption Spectrometry [DOI]
  20. 20 Nickel(II)-selective sensors based on heterogeneous membranes of macrocyclic compounds [DOI]
  21. 21 Evaluation of the determination of mercury at the trace and ultra-trace levels in the presence of high concentrations of NaCl by flow injection–cold vapour atomic absorption spectrometry using SnCl2 and NaBH4 as reductands [DOI]
  22. 22 Pentacyclooctaaza as a neutral carrier in coated-wire ion-selective electrode for nickel(II) [DOI]
  23. 23 Nickel(II) Selective PVC‐Based Membrane Sensor Using a Schiff Base [DOI]
  24. 24 New electrochemical sensors used for potentiometric determination of copper and nickel [DOI]
  25. 25 Potentiometric performance of a dioxime-type Schiff base as a silver-ion recognizable material. [DOI]
  26. 26 An optical redox chemical sensor based on ferroin immobilised in a Nafion® membrane [DOI]
  27. 27 Chelating ion-exchange resin membrane sensor for nickel(II) ions [DOI]
  28. 28 A PVC plasticized membrane sensor for nickel ions [DOI]
  29. 29 A PVC Plasticized Sensor for Ni(II) Ion Based on a Simple Ethylenediamine Derivative [DOI]
  30. 30 An optical membrane redox chemical sensor for the determination of ascorbic acid [DOI]
  31. 31 Liquid membrane ion-selective electrodes for potentiometric dosage of coper and nickel [DOI]
  32. 32 Potentiometric determination of neodymium (III) ions using tin (IV) antimonotungstate and zirconium (IV) antimonotungstate as electro-active materials [DOI]
  33. 33 Iron (III) Ion Sensor Based on the Seedless Grown ZnO Nanorods in 3 Dimensions Using Nickel Foam Substrate [DOI]
  34. 34 Copper ion selective electrode based on copper (II) complex of 4-Azocyanoacetamido-m-toludine antipyrine

Cited by 2

Potentiometric determination of nickel (II) with sodium diethyldithiocarbamate (NaDEDC)

A M Zakharkiva, S V Shumar · Journal of Physics: Conference Series · 2020

A Novel Iron(III) Potentiometric Sensor Based on (E)-N'-((2-hydroxynaphthalen-3-yl)methylene)benzohydrazide

Abdollah Yari, Marzieh Bagheri, Mahdieh Ghazizadeh · International Journal of Electrochemical Science · 2016

Related research

Article metrics

Real usage data collected on this platform.

10

Page views

0

PDF downloads

0

Outbound clicks

2

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.