Influence of Tillage, Residue, and Nutrient Management Practices on Physico-chemical and Biological Properties of Soil under Salt-affected Conditions in Wheat (Triticum aestivum L.) Crop
Manish Kumar, Kamalkant Yadav, Sahadeva Singh, Rashmi Soni, Sarika Mahor, Mahendra Anjna, Namrata Lodhi, Neelkamal Mishra, S. K. Goyal, Shani Gulaiya
International Journal of Plant & Soil Science · pp. 19–30 · Published 26 May 2026
10.9734/ijpss/2026/v38i66098Abstract
Sustainable soil management practices such as conservation tillage, residue retention, and integrated nutrient management are important for improving soil health and crop productivity under salt-affected conditions. The field experiment was conducted during the rabi season of 2022-23 at the Research Farm, School of Agriculture, Galgotias University, Greater Noida, Gautam Buddh Nagar, Uttar Pradesh, India. The experiment was laid out in a split-plot design with three replications. The main plot treatments consisted of two tillage systems, viz., zero tillage and conventional tillage. The sub-plot treatments comprised five residue and nutrient management practices: 100% rice residue (RN₁), no residue + 100% recommended dose of fertilizers (RDF) (RN₂), 100% rice residue + 75% RDF (RN₃), 100% rice residue + 100% RDF (RN₄), and 100% rice residue + 125% RDF (RN₅). The results revealed that tillage and residue–nutrient management practices had a non-significant effect on soil pH, organic carbon, and electrical conductivity. However, relatively higher values of organic carbon were observed under zero tillage and RN₅ (100% rice residue + 125% RDF), followed by RN₁ (100% rice residue). In contrast, available nitrogen (N), phosphorus (P), and potassium (K) were significantly influenced by the treatments, with values increasing over the initial soil status. Zero tillage in combination with residue and nutrient management practices significantly enhanced the availability of N, P, and K in the soil after crop harvest. The highest available N, P, and K were recorded under RN₅ (100% rice residue + 125% RDF). Furthermore, soil biological properties were markedly influenced by the treatments. The maximum microbial population of bacteria (39.06 × 10⁶ CFU g⁻¹), fungi (14.13 × 10³ CFU g⁻¹), and actinomycetes (21.63 × 10⁴ CFU g⁻¹) was recorded under zero tillage. Among residue and nutrient management practices, the highest microbial population of bacteria (39.79 × 10⁶ CFU g⁻¹), fungi (14.88 × 10³ CFU g⁻¹), and actinomycetes (22.12 × 10⁴ CFU g⁻¹) was observed with RN₅ (100% rice residue + 125% RDF).
Cited by 0
No indexed citations yet.
Related research
- A Comparative Study on Microbiological and Physico-chemical Properties of Three Local Alcoholic Beverages Produced and Consumed in Mombasa County, Kenya — shares topic coverage
- Physico-chemical and Microbiological Characteristics of a River Mud as substrate for Biological Generation of Electricity in the Niger Delta, Nigeria — shares topic coverage
- Physicochemical and Functional Properties of Pumpkin (Cucurbita Pepo) Pulp Flour and Acceptability of its Inclusion in Cake — shares topic coverage
- Physico-chemical Properties of Yoghurt Flavoured with Mmilo (Vangueria infausta) Pulp from Botswana — shares topic coverage
- Impact of Industrial Effluent Discharge on the Physico-chemical Properties of Aleto Stream, Eleme, Rivers State, Nigeria — shares topic coverage
Article metrics
Real usage data collected on this platform.
25
Page views
0
PDF downloads
3
Outbound clicks
0
Citations
Views over time
Views by country
Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".
Traffic sources
Referring site, by host.
Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.