Characterization of Clay from Isan Ekiti Deposits for Making the Ceramic Water Purifier

Abstract

Introduction: Despite the efforts of Governments and non-governmental organizations in sponsoring ceramic water purifier (CWP) filter project across the globe, some rural communities in Ekiti State, Nigeria are yet to benefit from it. One of the major technical difficulties hindering the making of CWP filter cells in many places was the adaptation to the sand, clay and sawdust mixture necessary to obtain the correct filter properties. Aim: In this study, some salient properties of clay from orudi, arade and oturo deposits at Isan Ekiti were assessed in the light of their usefulness for making the ceramic water filter cells. Methodology: The particle size distribution analysis and consistency tests were carried out on the crude clay. Also the shrinkage, effects of percentage constituents of burnout on porosity, filtration rate and quality of filtrate were measured, using standard methods. Results: Results show that arade has the appropriate technical properties for making the filter cell. The chosen clay sample has its deposit less than 2 kilometers to the point of making. About 56% of its particles are less than 0.075mm equivalent spherical diameter (ESD). A composition of ratio 50:50 by volume mixture of clay to sawdust has the   porosity of 54. 55% while that of ratio 40:60 is 55.56%. Samples made of these batches were capable of reducing the water turbidity Neflometric Turbidity Unit (NTU) of contaminated water by 95%.  The 50:50 samples have the higher capacity of reducing total coliform count by 50.28% as against 25.07% for 40:60 samples. Conclusion: Given appropriate facilities and training, with the abundant clay at arade deposit, the pottery center is a place where CWP filter cell factory could be established.