Skip to content
Research Article Open access CC BY 4.0

Assessing Structural Performance of Ceramic Waste as Partial Replacement of Coarse Aggregate on Properties of Concrete

Evans Biney, Vincent K. Akortia, Charles K. Kankam, John K. Quarm Junior, Peter Adzakey

Journal of Engineering Research and Reports · pp. 134–147 · Published 30 Nov 2022

10.9734/jerr/2022/v23i12771

Abstract

The need to reduce the increasing demand for crushed granite as coarse aggregate as well as the need to safeguard the environment from degradation has given rise to various researches on alternative materials that can serve the same purpose while minimizing environment hazard. This study assessed the suitability of waste ceramic tiles as coarse aggregate in concrete and to ascertain its strength against normal crushed granite. Crushed waste ceramic tiles from ceramic manufacturing industries and construction sites were mixed with crushed granite stones as partial replacement for concrete. A mix ratio of 1: 1.11: 2.72 (cement: sand: stones) for nominal C30 concrete was produced with (0, 10, 20, 30, 40, 50 and 100) percent volume ceramic waste aggregate replacement for crushed granite at a constant water-cement ratio of 0.5. Concrete cubes of size 150mm x 150mm x 150mm were produced and tested for 7 days and 28 days compressive strength, density and water absorption. The results revealed the viability of waste ceramic tiles as partial replacement for crushed granite in concrete production, but the partial replacement should not exceed 20% as recommended maximum for structural concrete. This mode of recycling ceramic waste could positively sustain the environment.

Ceramic waste partial replacement crushed granite concrete compressive strength

References (5)

  1. 1 Civil Engineering Materials [DOI]
  2. 2 A Case Study: Ceramic Tile Production [DOI]
  3. 3 PHYSICO-MECHANICAL PROPERTIES OF MORTAR MADE WITH BINARY NATURAL FINE AGGREGATES (DUNE SAND AND CRUSHED SAND) WITH AND WITHOUT CHEMICAL ADMIXTURE
  4. 4 Methods of test for soils for civil engineering purposes [DOI]
  5. 5 Specification for Portland Cement [DOI]

Cited by 9

Assessing Fresh Concrete Performance and Water Absorption Characteristics of Concrete with Partially Replaced Broken Tiles

Evans Biney, Vincent K. Akortia, Charles K. Kankam, John K. Quarm Junior, Peter Adzakey · Journal of Engineering Research and Reports · 2022

Pengaruh Penggunaan Abu Sekam Padi dan Limbah Granit Terhadap Kuat Tekan Beton

Debby Sinta Devi, Revianty Nurmeyliandari, Adelia Putri Pramadona · Borneo Engineering : Jurnal Teknik Sipil · 2024

A comprehensive review of local sustainable materials utilized in concrete production in Ghana

Jacqueline Obeng, Jonathan Sasah, Kwadwo Adinkrah-Appiah · Discover Sustainability · 2025

Showing 3 of 9 known citations — external sources report more than can currently be individually listed.

Article metrics

Real usage data collected on this platform.

12

Page views

0

PDF downloads

0

Outbound clicks

9

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.