Skip to content
Journal

Current Journal of Applied Science and Technology

Published by SCIENCEDOMAIN international · ISSN (electronic) 2457-1024

Search within this journal

4,428

Articles indexed

134

2026 articles

4,427

Open access

29,650

Citations (indexed)

Publications by year

Articles (4428)

Functionally Graded Coating Material of Cementless Knee Prosthesis

Saeed Ahmed Asiri, N. Fouda & H. S. Hedia · Current Journal of Applied Science and Technology · 2016

Surfaces are the primary place of contact a biomaterial and its host organism. Surface treatment or coating provides a means to overcome the problem which appeared after knee replacement surgery. There are two main problems; the stress shielding and subsequent bone remodeling cau...

Open access Research Article 10.9734/BJAST/2016/25618

Experimental Investigation of Shear Behavior of Deep RC T-beams Under Indirect Loading

Yousif Jabbar Lafta & Kun Ye · Current Journal of Applied Science and Technology · 2016

The main goal of present study is to experimentally and analytically investigate the behavior of indirect loading, deep flanged reinforced concrete (RC) beams. The load is applied via shear on the side arms of the beam with bearing plates. Eighteen reinforced concrete deep T- bea...

Open access Research Article 10.9734/BJAST/2016/25264

One-dimensional Geotemperature Modeling Using One-layer Model for Awa Oil Field, Niger Delta Sedimentary Basin, Nigeria Using One Layer Model

Emujakporue Godwin Omokenu · Current Journal of Applied Science and Technology · 2016

In this research, one-dimensional steady state thermal structure in part of Niger Delta sedimentary basin has been modelled using one layer model. The solution to the Fourier one dimensional heat flow was used to generate geotherm the area. The model column is about 7.0 Km thick,...

Open access Research Article 10.9734/BJAST/2016/25830

Classical Identification, 16S rDNA Sequencing, and Molecular Characterization of Bacillus species from Convenience Foods

C. E. Aruwa & S. T. Ogunlade · Current Journal of Applied Science and Technology · 2016

Identification of microorganisms is central to the study of microbiology at all levels of research. The methods employed are also important. It is however very pertinent that scientists the world over continuously improve on the method of microbial identification for greater effi...

Open access Research Article 10.9734/BJAST/2016/24803

Development of Ant Colony Optimization Software as a Solid Waste Management System

Oghenefejiri Bovwe, Ify L. Nwaogazie & J. C. Agunwamba · Current Journal of Applied Science and Technology · 2016

In this paper a Decision Support System named W8st colSoft is developed by employing dynamic programming and swarm intelligence model encoded in Visual Basic Studio 10.0. Solved solutions from literatures were used to validate the developed decision support system. The results ob...

Open access Research Article 10.9734/BJAST/2016/25080

Business Intelligence Readiness for Higher Learning Institution (IHL): Preliminary Study and Research Model

Abdul Razak Rahmat, Azizah Ahmad & Azman Ta’a · Current Journal of Applied Science and Technology · 2016

Introduction: Business Intelligence Systems (BIS) are the most potential application for many popular organizations in different industries such as telecommunication, healthcare, airline, transport, government and others. The implementation of Business Intelligence (BI) for Insti...

Open access Research Article 10.9734/BJAST/2016/24383

Antimicrobial Activity and Allelopathic Potential of Zygophyllum coccineum L. on Chenopodium album L.

Hamed M. El-Shora, Yaser A. El-Amier & Menna H. Awad · Current Journal of Applied Science and Technology · 2016

Zygophyllum coccineum L. (Family Zygophyllaceae) was collected from two locations namely Wadi Hagul and Deltaic Mediterranean coast. Methanol, acetone and ethanol extracts prepared from Z. coccineum leaves and they were tested for their antibacterial activity. The bacterial strai...

Open access Research Article 10.9734/BJAST/2016/24541

Enhancing the Strength Characterisitics of Concrete Through the Use of Steel Fibre

F. A. Olutoge, G. M. Amusan & S. O. A. Olawale · Current Journal of Applied Science and Technology · 2016

The paper aims at studying the strength characteristics of steel fibre reinforced concrete (SFRC), within the fibre dosage of 0.5 to 2%. Discontinuous discrete steel fibres were explored in concrete of grade M60, and normal concrete of 0% steel fibre dosage used as control. The c...

Open access Research Article 10.9734/BJAST/2016/25037