Addressing Off-Centered Ball through Solder Paste Material Evaluation
B. C. Bacquian, F. R. Gomez, E. Graycochea Jr., N. Gomez
Journal of Engineering Research and Reports · pp. 15–18 · Published 11 Dec 2020
10.9734/jerr/2020/v19i317233Abstract
Stencil printing using solder paste material is one of the challenging processes in semiconductor assembly manufacturing. During evaluation of a semiconductor device, off-centered ball issue was encountered. The study aimed to mitigate the off-centered ball issue at stencil printing process by exploring the effect of different solder paste materials. Both solder paste materials were cured using the same reflow condition. However, solder paste material 1 (S1) resulted to cold solder joints while material 2 (S2) showed cured solder paste characteristic. With S2 material used in stencil printing, the off-centered ball occurrence was eventually eliminated. For future works, the solder paste material and configuration could be used for devices with similar requirement.
Cited by 0
No indexed citations yet.
Related research
- Ball Misplace Mitigation through Process Optimization of Advanced Leadframe Package — shares topic coverage
- Glue Voids Reduction on QFN Device through Material and Process Improvement — shares topic coverage
Article metrics
Real usage data collected on this platform.
0
Page views
0
PDF downloads
0
Outbound clicks
0
Citations
Views by country
Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".
No views recorded yet.
Traffic sources
Referring site, by host.
No traffic recorded yet.
Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.