Skip to content
Research Article Open access CC BY 4.0

Chromium (VI) Ions Removal from Tannery Effluent using Chitosan-Microcrystalline Cellulose Composite as Adsorbent

Shahida Yasmeen, Mrinal Kanti Kabiraz, Badhan Saha, Md. Rakibul Qadir, Md. Abdul Gafur, Shah Md. Masum

International Research Journal of Pure and Applied Chemistry · pp. 1–14 · Published 31 Dec 2015

10.9734/IRJPAC/2016/23315

Abstract

The bio-adsorbent chitosan-microcrystalline was synthesized from waste materials of shrimp processing industries, and waste cotton rags of garments industries for removal of chromium (VI) ion from tannery effluent. The chitosan was extracted from shrimp shell through the deproteinization, demineralization and deacetylation steps and microcrystalline cellulose was extracted from waste cotton rags by acid hydrolysis. The composite was prepared by simple solution evaporation method. The functional groups, responsible for adsorption and the chemical interaction in the composite formation were evidenced from FTIR results. The observed SEM results indicate that the prepared composite has a rough and porous surface. Batch adsorption experiments were conducted and removal of Cr(VI) was found to be reliant on pH and maximum adsorption was observed at pH 5.0. For 2 ppm Cr(VI) stock solution, the optimum dose and contact time treatment was 2 g/L and 240 minutes respectively and the maximum removal efficiency of chromium was found 93%. Tannery effluent was treated with optimum conditions required for maximum removal of Cr(VI). Langmuir isotherm and Freundlich isotherm model were plotted against the adsorption data and found that Langmuir Isotherm was well fitted with R2 value of 0.997.  

Chitosan-microcrystalline cellulose composite chromium (VI) Scanning Electron Microscopy (SEM) sorption tannery effluent treatment chitosan

Cited by 109

Treatment of acid mine drainage and chromium (VI) removal using synthesised chitosan composites blended with kenaf fibre and γ-Fe_2O_3 nanoparticles

C. Nkuna, E. R. Sadiku, G. Perry · International Journal of Environmental Science and Technology · 2022

Surface modifications of low-density polyethylene films with hydrophobic and antibacterial properties by chitosan-based materials

Na Ren, A. Petchsuk, M. Opaprakasit · Polymer-Plastics Technology and Materials · 2022

Cu(II) metal-organic framework@Polydimethylsiloxane nanocomposite sponges coated by chitosan for antibacterial and tissue engineering applications

Zeinab Ansari-Asl, Zahra Shahvali, Reza Sacourbaravi · Microporous and Mesoporous Materials · 2022

High-Power Laser Deposition of Chitosan Polymers: Medical and Environmental Applications

Georgiana Cocean, A. Cocean, C. Postolachi · Polymers · 2022

Evaluation of the impact of guar gum applied to chemical enhanced oil recovery on produced water treatment using a SDBS-Chitosan flocculant system

Allan S. Santos, A. M. Marques, L. C. Palermo · Energy Sources, Part A: Recovery, Utilization, and Environmental Effects · 2022

Preparation of new MOF-808/chitosan composite for Cr(VI) adsorption from aqueous solution: Experimental and DFT study.

F. M. Valadi, Shayan Shahsavari, E. Akbarzadeh · Carbohydrate Polymers · 2022

Article metrics

Real usage data collected on this platform.

0

Page views

0

PDF downloads

0

Outbound clicks

109

Citations

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

No views recorded yet.

Traffic sources

Referring site, by host.

No traffic recorded yet.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.