Skip to content
Research Article Open access CC BY 4.0

Study and Design of a Mobile Hydraulic Lift Table with Single Scissors

Guy Clarence Sèmassou, Roger Ahouansou, Edmond Claude Vodounnou, Guidi Tognon Clotilde

Physical Science International Journal · pp. 32–43 · Published 22 Nov 2021

10.9734/psij/2021/v25i830276

Abstract

The “BENIN TERMINAL” machines are maintained by company technicians who encounter difficulties in the operations carried out on these machines. In fact, it is about improving the procedure for installing and removing engines and gearboxes for BENIN TERMINAL mobile vehicles through the study and design of a single scissor lift table. It has a lifting capacity of 2 tons, a width of 900 mm, a total length of 1900 mm and a maximum height of 2000 mm using a hydraulic system. It works with 12 V batteries, simple and height-adjustable workspace. The lifting table also allows certain operations requiring an average height to be carried out.This device was developed for the BENIN TERMINAL garage in order to reduce the efforts and risks encountered by technicians when installing or removing engines and gearboxes on certain machines, in particular heavy machines such as Reach Stackers and 16ton forklifts.

Assembly gearboxes sizing lifting table maintenance

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

17

Page views

0

PDF downloads

2

Outbound clicks

0

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.