Skip to content
Research Article Open access CC BY 3.0

Seed Moisture Influence on Some Physical and Mechanical Properties of African Mesquite (Prosopis africana)

Sadiku Olajide, Fadele Oluwaseyi, Makinde Dolapo

Journal of Scientific Research and Reports · pp. 2348–2361 · Published 20 Jul 2014

10.9734/JSRR/2014/8116

Abstract

The physical and some mechanical properties of Prosopis africana seeds (African mesquite) as affected by seed moisture content in the range 10–22% wet basis (w.b.) were investigated. Mohsenin, Stepanoff and ASABE standard methods were used in determining the properties. Results showed that there was increase in seed length (11.40–12.90 mm), width (8.10– 9.60 mm) and thickness (4.8–5.9 mm) while arithmetic and geometric mean diameters increased in the range; 8.1–9.4 mm and 7.5–8.9 mm respectively. Increases in bulk density (508 – 856 kgm-3), surface area (176 – 249 mm2) and sphericity (0.66–0.70) were recorded while a decrease was observed in true density (1205.9–1090 kgm-3) with increasing seed moisture content. Increase was also observed in static angle of repose (30.8 - 36.2o). Static coefficient of friction increased on plywood (26.7 - 32.2), glass (25.7 - 33.8), mild-steel (26.2 - 31.0), galvanized iron (27.5 - 32.7), rubber (27.5 - 31.5), aluminium (26.0 - 28.5) and stainless steel (24.0 - 31.8). Shear stress was highest at 22% moisture wet basis (w.b.) under 500 g load (6.3 gcm-2) and lowest at 10% moisture w.b., under 200g load (2.0 gcm-2). Effect of seed moisture content on all the properties was statistically significant (P=.05) except static coefficient of friction on aluminium and mild steel surfaces. All the properties are pre-requisite for the engineering design and development of equipment for the handling and processing of African mesquite; the purpose for which baseline data was developed in this work.

Bulk density seed volume shear stress porosity sphericity angle of repose internal friction.

References (14)

  1. 1 Some Physical Properties of Hemp Seed [DOI]
  2. 2 Some physical properties of fenugreek (Trigonella foenum-graceum L.) seeds [DOI]
  3. 3 Effect of moisture content on some physical and mechanical properties of faba bean (Vicia faba L.) grains [DOI]
  4. 4 PH—Postharvest Technology [DOI]
  5. 5 Moisture dependent physical properties of cucurbit seeds
  6. 6 The Effect of Moisture Content on Physical Properties of Wheat [DOI]
  7. 7 Some Physical and Engineering Properties of Prosopis africana seed [DOI]
  8. 8 SOME PHYSICAL PROPERTIES OF TWO AFRICAN YAM BEAN (SPHENOSTYLIS STENOCARPA) ACCESSIONS AND THEIR INTERRELATIONS WITH MOISTURE CONTENT [DOI]
  9. 9 EFFECT OF MOISTURE CONTENT ON SOME PHYSICAL PROPERTIES OF LOCUST BEAN SEED (PARKIA FILLICOIDEA L.) [DOI]
  10. 10 Some Physical AND Mechanical Properties of Iranian Wild Pistachio (pistachio Mutica L.)
  11. 11 Moisture-Dependent Engineering Properties of Chia (Salvia hispanica L.) Seeds [DOI]
  12. 12 Some Engineering Properties of Prosopis Africana Pods Relevant to Dehulling
  13. 13 Selected properties of yellow lupine seeds formed by hydration
  14. 14 Mechanical properties of pomegranate seeds affected by moisture content.

Cited by 1

Effects of Drying On Some Engineering Properties of African Locust Bean Seeds

P. Ajewole, T. Ayelegun, I. O. Oni · 2018

Related research

Article metrics

Real usage data collected on this platform.

60

Page views

0

PDF downloads

30

Outbound clicks

1

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.