Skip to content
Research Article Open access CC BY 3.0

Reactive DC Magnetron Sputtered NbN Films on Mild Steel with Electroless Nickel Interlayer

Kulwant Singh, M. R. Gonal, N. Krishnamurthy

Journal of Scientific Research and Reports · pp. 1162–1175 · Published 22 Mar 2014

10.9734/JSRR/2014/7355

Abstract

Aims: To explore the benefits of NbN coating on mild steel (MS) with electroless nickel (EN) interlayer. Study Design: To deposit NbN coatings at various N2/Ar flow-ratios and substrate biasing; optimize the parameters and then deposit NbN on MS with EN interlayer. Place and Duration of Study: Material Processing Division, Bhabha Atomic Research Centre, Trombay, Mumbai, between June 2010 and July 2012. Methodology: NbN was deposited by reactive DC magnetron sputtering varying N2/Ar flow ratio between 5-70% and substrate biasing from zero to -150V. Coatings were studied for thickness, hardness, phase analysis and adhesion. Effect of EN interlayer was studied for improvement in hardness, adhesion and corrosion. Corrosion was studied using potentiodynamic polarization technique in 1N H2SO4 solution at room temperature. Results: X-ray diffraction showed hexagonal β Nb2N, cubic δ NbN and hexagonal δ’NbN phases with increasing N2. EN layer was found to be amorphous. When NbN top-coat was deposited by sputtering, EN structure changed to crystalline Ni3P and Ni. Surface hardness increased from 1084HK25 for NbN/MS to 1436, 1564 and 1612HK25 with EN interlayer in 2, 4 and 10µm thickness respectively. In the scratch tests, critical load for cohesive failure varied between 6-8N, 8-15N and 8-18N and critical load for adhesive failure varied between 9-12N, 12-25N and 10-28N for NbN coating on MS, SS and MS/EN respectively. Coefficient of friction (µ) in the scratch adhesion tests for NbN/MS was 0.28 at 30N, 0.35 at 40N and 0.45 at 60N load; for NbN/EN/MS, µ decreased to 0.22, 0.28 and 0.37 at 30, 40 and 60N loads respectively, demonstrating the improvement. Corrosion studies showed that Icorr decreased from 150.2µA/cm2 for NbN/MS to 2.3, 0.37 and 0.35µA/cm2 with 2, 4 and 10µm thick EN interlayer respectively. Conclusion: There was considerable improvement in the hardness, corrosion resistance and adhesion of NbN/MS, when incorporated with EN interlayer.

Magnetron-sputtering NbN electroless nickel corrosion adhesion hardness

References (40)

  1. 1 On the significance of the H/E ratio in wear control: a nanocomposite coating approach to optimised tribological behaviour [DOI]
  2. 2 Different approaches to superhard coatings and nanocomposites [DOI]
  3. 3 Comparative study of chromium nitride coatings deposited by unbalanced and balanced magnetron sputtering [DOI]
  4. 4 Microstructure of CrN coatings produced by PVD techniques [DOI]
  5. 5 Effect of electroless nickel interlayer on the electrochemical behavior of single layer CrN, TiN, TiAlN coatings and nanolayered TiAlN/CrN multilayer coatings prepared by reactive dc magnetron sputtering [DOI]
  6. 6 Structural and mechanical properties of sputtered cubic and hexagonal NbN thin films [DOI]
  7. 7 A comparative study of CrNx coatings Synthesized by dc and pulsed dc magnetron sputtering [DOI]
  8. 8 The effects of pulse frequency and substrate bias to the mechanical properties of CrN coatings deposited by pulsed DC magnetron sputtering [DOI]
  9. 9 The deposition of NbN and NbC thin films by filtered vacuum cathodic arc deposition [DOI]
  10. 10 Deposition of TiN thin films on Si(100) by HCD ion plating [DOI]
  11. 11 Characterization of titanium nitride films prepared by d.c. reactive magnetron sputtering at different nitrogen pressures [DOI]
  12. 12 Growth and characterization of aluminum nitride coatings prepared by pulsed-direct current reactive unbalanced magnetron sputtering [DOI]
  13. 13 Corrosion behaviour of decorative and wear resistant coatings on steel deposited by reactive magnetron sputtering – Tests and improvements [DOI]
  14. 14 The effect of nitrogen pressure on cathodic arc deposited NbN thin films [DOI]
  15. 15 Effects of radio-frequency plasma on structure and properties in Ti film deposition by dc and pulsed dc magnetron sputtering [DOI]
  16. 16 Ion induced stress generation in arc-evaporated TiN films [DOI]
  17. 17 Comparison of structural and chemical properties of Cr-based hard coatings [DOI]
  18. 18 Morphological, structural and mechanical properties of NbN thin films deposited by reactive magnetron sputtering [DOI]
  19. 19 The growth and diffusion barrier properties of atomic layer deposited NbNx thin films [DOI]
  20. 20 Adhesion and wear studies of magnetron sputtered NbN films [DOI]
  21. 21 Tribological characterization of chromium nitride coating deposited by filtered cathodic vacuum arc [DOI]
  22. 22 Characterization of reactive magnetron sputtered nanocrystalline titanium nitride (TiN) thin films with brush plated Ni interlayer [DOI]
  23. 23 Deposition of NbN thin films by DC magnetron sputtering process [DOI]
  24. 24 Pulsed laser ablation of NbN/MgO/NbN multilayers [DOI]
  25. 25 Filter effects on the wear and corrosion behaviors of arc deposited (Ti,Al)N coatings for application on cold-work tool steel [DOI]
  26. 26 Properties of niobium nitride coatings deposited by cathodic arc physical vapor deposition [DOI]
  27. 27 Effect of sputtering power on the properties of Cd1−xZnxTe films deposited by radio frequency magnetron sputtering [DOI]
  28. 28 Influence of Nitrogen Content on the Structural and Mechanical Properties of TiN Thin Films
  29. 29 The influence of a heat treatment on the microstructure and mechanical properties of sputtered coatings [DOI]
  30. 30 Microhardness and corrosion behavior in CrN/electroless Ni/mild steel complex coating [DOI]
  31. 31 Single-crystal niobium nitride thin films prepared with radical beam assisted deposition [DOI]
  32. 32 Scratch behavior and in situ acoustic emission analysis of PVD chromium nitride coatings on mild steel with electroless nickel interlayers [DOI]
  33. 33 Effect of electroless nickel interlayer on wear behavior of CrN/ZrN multilayer films on Cu-alloyed ductile iron [DOI]
  34. 34 Evaluation of the mechanical properties and tribological behavior of the CrN coating deposited on mild steel modified with electroless Ni interlayer [DOI]
  35. 35 The effect of transport ratio and ion energy on the mechanical properties of IBAD niobium nitride coatings [DOI]
  36. 36 TiN Coatings on Nickel and Electroless Nickel (EN) Plated Mild Steel [DOI]
  37. 37 TiN Coatings Modified by an Interlayer of Electroplated Chromium on Mild Steel [DOI]
  38. 38 Mechanical Properties of TiN Whiskers [DOI]
  39. 39 An empirical analysis of nitrogen pressure effect on grain size development of nanostructured ternary nitride coatings
  40. 40 Handbook of deposition technologies for films and coatings

Cited by 0

No indexed citations yet.

Article metrics

Real usage data collected on this platform.

75

Page views

0

PDF downloads

43

Outbound clicks

0

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.