Skip to content
Research Article Open access CC BY 4.0

Hydraulic Vibration Hammer without Resonance Technology Status Study

Li Yupeng, You Rongyu

Journal of Engineering Research and Reports · pp. 185–192 · Published 8 Dec 2022

10.9734/jerr/2022/v23i12776

Abstract

Hydraulic vibratory hammer using the working principle of vibratory pile sinking is an important equipment in pile foundation construction, which can be used for sinking and extracting piles. It has a wider range of application than the drop hammer for pile sinking by the impact method and the static hammer for pile sinking by the press-in method, which can significantly reduce the resistance of piles during sinking and extraction and improve the working efficiency. However, it is difficult to avoid the resonance phenomenon in the process of starting and stopping by using the principle of vibratory pile sinking, and the resonance phenomenon will cause a high concentration of stress in the vibratory pile hammer parts and reduce its service life. In this paper, the resonance-free technology of hydraulic vibratory hammer is studied in the hope of promoting the development of hydraulic vibratory hammer. On this basis, the technology of innovative hydraulic vibratory hammer without resonance is used to reduce its cost and promote commercialization.

Hydraulic vibratory hammer vibratory pile-sinking resonance-free

References (14)

  1. 1 Construction machinery and equipment [DOI]
  2. 2 Nonlinear Interaction of Soil–Pile in Horizontal Vibration [DOI]
  3. 3 Design and dynamical simulation to new vibrating centrifuge with wider frequency range [DOI]
  4. 4 Transmission of Power by Sinusoidal Wave Motion through Hydraulic Oil in a Uniform Pipe [DOI]
  5. 5 A Three Phase Pulsating Flow Hydraulic Control System
  6. 6 Effects of Exciter Parameters on Self-Synchronous Vibration System
  7. 7 Behaviour analysis of excess pore pressure due to vibratory pile driving using the high frequency hydraulic vibratory hammer
  8. 8 Design and dynamics analysis of a new type of vibration pile driver and drawer
  9. 9 Design of a Novel Broad-Band Vibrator
  10. 10 Vibratory piling hammer with pile driver without resonance and its hydraulic control system
  11. 11 Vibration Penetration Process Simulation of Pile Based on ANSYS
  12. 12 Main Parameters Selection and Calculation for Pile Hammer of Vibration Pile Driver Extractor
  13. 13 Effect of Amplitude Modulation of Hydraulic Vibration Hammer on Piling Efficiency
  14. 14 A study and analysis of a three-phase pulsating flow hydraulic system

Cited by 1

Construction and control parameter matching method of hydraulic pile hammer surrogate model combining transfer algorithm and knowledge embedding

Hong-Qi Jiang, Xiao Jiang · Discover Applied Sciences · 2024

Article metrics

Real usage data collected on this platform.

4

Page views

0

PDF downloads

0

Outbound clicks

1

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.