Skip to content
Research Article Open access CC BY 3.0

Enhancing AC Electrothermal Micropumping by Integrating Temperature Bias and Surface Modification

Nazmul Islam

Journal of Scientific Research and Reports · pp. 1465–1474 · Published 21 Apr 2014

10.9734/JSRR/2014/8876

Abstract

This paper describes an experimental study of the improvement of bi-directional AC (Alternating Current) electrothermal micropump velocity by a surface modification process and the addition of a temperature bias. The work focuses on exploiting external temperature bias to enhance micropumping by AC electrothermal (ACET) effect. Adding temperature bias to a symmetrical electrode setup provides an advantage of bi-directional characteristic. Here an integrated AC micropump design is proposed, which is expected to solve the problem of on-chip pumping for biofluids. A polymer base nanocomposite coating consisting of a homogeneous mixture of silicon nanoparticles in polydimithylsiloxane (PDMS) is used to improve the hydrophobicity of the micropump surfaces. Due to the hydrophobic nature of PDMS and the monolayer coating with nanoscale surface roughness, the hydrophilic surface of temperature biased ACET micropump will transform to a hydrophobic surface. In addition to hydrophobicity improvement, adding a thin nanocomposite monolayer will physically separate the electrodes from the pumping liquid, thus eliminating their reaction, which is usually observed due to the application of voltage. In addition, the surface modification of micropump will decrease the friction loss and improve the pumping velocity. All experiments were done at 100 kHz VAC that also suppress the bubble generation. As a result, we could apply 7.5 Vrms (equivalent to 21.2 V, peak to peak) voltages to the symmetrical electrode arrays and higher pumping rates (2100 microns/sec) are achieved.

AC electrothermal micropump symmetrical electrode biomedical hydrophobic coating nanocomposite monolayer surface modification.

References (15)

  1. 1 Fluid flow induced by nonuniform ac electric fields in electrolytes on microelectrodes. I. Experimental measurements [DOI]
  2. 2 Recent advances in microscale pumping technologies: a review and evaluation [DOI]
  3. 3 A planar electroosmotic micropump [DOI]
  4. 4 An integrated AC electrokinetic pump in a microfluidic loop for fast and tunable flow control [DOI]
  5. 5 Pumping of liquids with ac voltages applied to asymmetric pairs of microelectrodes [DOI]
  6. 6 Thin PDMS Films Using Long Spin Times or Tert-Butyl Alcohol as a Solvent [DOI]
  7. 7 AC electrothermal manipulation of conductive fluids and particles for lab-chip applications [DOI]
  8. 8 A theoretical and experimental study of ac electrothermal flows [DOI]
  9. 9 Hybrid opto-electric manipulation in microfluidics—opportunities and challenges [DOI]
  10. 10 Enhanced electrothermal pumping with thin film resistive heaters [DOI]
  11. 11 3D3C velocimetry measurements of an electrothermal microvortex using wavefront deformation PTV and a single camera [DOI]
  12. 12 Microfluidic flow reversal at low frequency by AC electrothermal effect [DOI]
  13. 13 Novel systems for configurable AC electroosmotic pumping [DOI]
  14. 14 Electric field-decoupled electroosmotic pump for microfluidic devices [DOI]
  15. 15 Improving the Pumping Efficiency of a Micropump Using Hydrophobic Nanocomposite Coating [DOI]

Cited by 1

Modeling of Electrothermal Flow Mixing in Lab on Chip Microfluidic Devices

Vishaka B Wasnik · 2016

Related research

Article metrics

Real usage data collected on this platform.

54

Page views

0

PDF downloads

30

Outbound clicks

1

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.