Skip to content
Research Article Open access CC BY 3.0

Electrophoretic Deposition of Alumina and Nickel Oxide Particles

Bintou Ouedraogo, Oumarou Savadogo

Journal of Scientific Research and Reports · pp. 190–205 · Published 22 Mar 2013

10.9734/JSRR/2013/2559

Abstract

Electrophoretic deposition (EPD) of alumina and nickel oxide particles on nickel substrate has been investigated. Pure ethanol and a mixture of ethanol and water were used as solvents. The stability of Al2O3 and NiO suspension in two solvents was studied and compared in terms of zeta potential, electrophoretic mobility and conductivity. The influence of different solvents and deposition parameters such as suspension conductivity, applied voltage and time of deposition on the weight gain and the morphology of deposits were also evaluated. The results demonstrated that mixture of ethanol and water as a solvent appears to be advantageous over pure ethanol for EPD of Al2O3 and NiO from standpoint of a good stability of suspension, a higher electrophoretic mobility and also due to the uniform deposits in terms of microstructures and thicknesses. Studies the relationship between the increase in applied voltage during EPD and the decrease in conductivity, have shown that the increase in voltage was completely caused by the decrease in conductivity of suspension.

Electrophoretic deposition ethanol solvents conductivity Al2O3 NiO

References (21)

  1. 1 Electrophoretic Deposition (EPD): Mechanisms, Kinetics, and Application to Ceramics [DOI]
  2. 2 Formation of a deposit by electrophoresis [DOI]
  3. 3 Electrophoretic deposition of nickel oxide electrode for high-rate electrochemical capacitors [DOI]
  4. 4 Electrophoretic deposition of aqueous alumina slips [DOI]
  5. 5 Functionally graded ceramic/ceramic and metal/ceramic composites by electrophoretic deposition [DOI]
  6. 6 Fabrication of ceramic composite coatings using electrophoretic deposition, reaction bonding and low temperature sintering [DOI]
  7. 7 Functionally graded ceramic and ceramic–metal composites shaped by electrophoretic deposition [DOI]
  8. 8 The conductivity of aqueous Al2O3 slips for electrophoretic deposition [DOI]
  9. 9 The preparation of AI2O3/Ni composites by a powder coating technique [DOI]
  10. 10 Preparation of NiO-YSZ/YSZ bi-layers for solid oxide fuel cells by electrophoretic deposition [DOI]
  11. 11 Stability of aqueous TiO2 suspensions: influence of ethanol [DOI]
  12. 12 Influence of the suspension composition on the electric field and deposition rate during electrophoretic deposition [DOI]
  13. 13 Effect of the slurry properties on the homogeneity of alumina deposits obtained by aqueous electrophoretic deposition [DOI]
  14. 14 Fabrication of alumina parts by electrophoretic deposition from ethanol and aqueous suspensions [DOI]
  15. 15 Electrophoretic deposition of poly[3-(3-N,N-diethylaminopropoxy)thiophene] and composite films [DOI]
  16. 16 Ni-Al2O3 cermet solar absorbers by RF planar magnetron sputtering for high temperature applications [DOI]
  17. 17 Electrophoretic deposition of alumina on stainless steel from non-aqueous suspension [DOI]
  18. 18 Nickel–Alumina Functionally Graded Materials by Electrophoretic Deposition [DOI]
  19. 19 Electrophoretic forming of silicon carbide ceramics [DOI]
  20. 20 A New Approach to Synthesizing NiO-YSZ Nanocomposite as Solid-Oxide Fuel-Cell Anode Functional Layers by Electrophoretic Deposition [DOI]
  21. 21 L’industrie céramique [DOI]

Cited by 16

Optimization of Tensile Strength and Young’s Modulus of CNT–CF/Epoxy Composites Using Response Surface Methodology (RSM)

Md. Rezaur Rahman, Nur-Azzah Afifah Binti Taib, Mohammed Mahbubul Matin · Materials · 2022

Progress in Electrochemical and Electrophoretic Deposition of Nickel with Carbonaceous Allotropes: A Review

Shikha Awasthi, Sarvesh Kumar Pandey, Chandra Prabha Pandey · Advanced Materials Interfaces · 2019

High Microwave Absorption of Nano-Fe3O4Deposited Electrophoretically on Carbon Fiber

Karim Osouli-Bostanabad, Hossein Aghajani, Ehssan Hosseinzade · Materials and Manufacturing Processes · 2015

Electrophoretic deposition of high adhesion energetic coatings (e.g., NiO-Al/Fe2O3)

Daixiong Zhang, Xinxi He, Mei Huang · Chemical Engineering Journal · 2025

Application aspects of joint anaphoresis/substrate anodization in production of biocompatible ceramic coatings

Katarina Bozic, Miroslav Pavlovic, Gavrilo Sekularac · Journal of the Serbian Chemical Society · 2023

Influence of ion mobility and electrode structure effects on supercapacitors with CaO, MgO, and SiO2

Önder Yargı, Eda Bostancı, Bilge Coşkuner Filiz · Ionics · 2024

Showing 8 of 16 known citations — external sources report more than can currently be individually listed.

Article metrics

Real usage data collected on this platform.

63

Page views

0

PDF downloads

27

Outbound clicks

16

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.