Skip to content
Research Article Open access CC BY 4.0

Effect of Silica Flour and Potasium Chloride as Additives in the Rhelogical Properties of High Temperature High Pressure Gas Well Cement Slurry

Amuah Freda Roli, Ogbonna Joel, Anthony John

Journal of Engineering Research and Reports · pp. 66–78 · Published 22 Jun 2023

10.9734/jerr/2023/v25i4903

Abstract

This study explores the effects of silica flour and potassium chloride on the rheological properties of high temperature and pressure gas wells. Seven different materials were used as additives which includes: fresh water, dyckerhoff, silica flour, antifoam, extender, fluid loss, dispersant, retarder, anti-settling agent, gas control agent, dry viscosifier, potassium chloride and accelerator. Four recipes were prepared using these additives in different mixtures. Recipe four has all the additives including silica flour and potassium chloride. A series of flow tests was performed using an advanced shear-stress/shear strain controlled rheometer. Rheological properties of cement slurries were calculated from the resulting flow curves using the Bingham plastic model and the Herschel–Bulkley’s model. Changes in shear stress–shear rate relationships, yield stress, plastic viscosity, and shear thinning/thickening behavior were found to be related to temperature and the type and dosage of supplementary cementitious material. The four recipes were applied in 10 cases. Among the four different recipes tested for all the 10 cases, Recipe 4 has the best regression values for both temperature vs transit time and pressure vs transit time this can be attributed to the presence of silica flour and potassium chloride.

Additives slurry rheology temperature pressure

References (10)

  1. 1 HPHT Well Integrity and Cement Failure [DOI]
  2. 2 Oil Well Cement Static Gel Strength Development Comparison Between Ultrasonic and Intermittent Rotational Measurement Methods [DOI]
  3. 3 Optimum Practices to Mitigate Gas Migration Problems in Deep Gas Wells [DOI]
  4. 4 Well Integrity Improvement: CCA Preventive Actions in HPHT Offshore Gas Wells in the Arabian Gulf [DOI]
  5. 5 Challenges in HPHT Well: A Case Study [DOI]
  6. 6 Effects of Additive Concentrations on Cement Rheology at Different Temperature Conditions [DOI]
  7. 7 Offline Cementing Technique [DOI]
  8. 8 Ensuring Zonal Isolation in Cementing Jobs of Gas Well [DOI]
  9. 9 Prevention of Shallow Gas Migration Through Cement [DOI]
  10. 10 Case Study: Planning and Execution of a Subsea Hpht Well in the Niger-Delta [DOI]

Cited by 2

Effect of fullerene soot on the properties of grouting mixtures

V. Kovalchuk · Building and reconstruction · 2026

Showing 1 of 2 known citations — external sources report more than can currently be individually listed.

Article metrics

Real usage data collected on this platform.

6

Page views

0

PDF downloads

0

Outbound clicks

2

Citations

Views over time

Views by country

Approximate, from request IP at view time — not citizenship or institution. Countries with fewer than 5 views are grouped as "Other".

Traffic sources

Referring site, by host.

Views and downloads exclude known bots/crawlers. Citations combines this platform's own DOI-resolved index with each external source's own reported total — see Cited by above for individually listed citing works. Last refreshed 0 seconds ago.