Acid Challenge on Push-Out Bond Strength of Three Different Tricalcium Silicate Cements: An In-vitro Study

Abstract

Aim: To evaluate the impact of environmental pH on intra-radicular dentin push-out bond strengths of MTA, MTA HP, and Biodentine. Materials and Methodology: Freshly extracted human mandibular single-rooted premolars or maxillary anterior incisors that were either intact or contained only small carious lesions were selected.120 mid root dentins is horizontally divided into 1.0 mm thick slices and divided into 3 MTA, MTA HP, BIODENTINE groups. The compressive load is applied at a speed of 0.5 mm/min by exerting a downward pressure on the outer surface of MTA using a 1.00 mm diameter cylindrical stainless-steel plunger. Maximum load to MTA was reported in newtons at the time of dislodgement and converted to megapascals. The 1-way analysis of variance test was used to compare the push-out bond strength of the groups with the same storage time (4 or 34 days), followed by the pair-wise comparison of the Tukey post hoc test. The Student's t-test was used to evaluate 3-group means. At P = .005, the degree of significance was set. Thus the clinical importance of the present study states that considering several factors like microhardness, composition by products, particle sizes and the environmental pH plays a critical role in selection of root end filling material. Results: There was significant difference between groups (P = .001) after 4 days of PBS and Acid condition, where Bio dentine had significantly the highest bond strength. Conclusion: The strength of MTA HP, BIODENTINE, MTA materials at dentine interface increases over 30 days in the storage of PBS solution at pH 7.4, after an initial acid challenge by acetic acid of pH 5.4, which decreases initial bond strength.